PAGlink batteries can provide up to 12A when linked, which makes them ideal for power-hungry camera set-ups that include multiple accessories. The low-profile, lightweight PAGlink PowerHub is an accessory power plate that provides all the outputs you need via plug-in units. It is designed to be used between two PAGlink batteries so that the rear battery can be hot-swapped for continuous power without disconnecting the camera accessories; this is not possible when you power accessories from D-Taps built into the battery.

The low-profile, lightweight PAGlink PowerHub provides four outputs for 12V camera accessories, such as on-board lights, monitors, audio equipment and transmission devices. It incorporates four D-Tap outputs and one USB (2A 5V) output as standard. These are interchangeable with other plug-in output units, available individually: Hirose (4-pin), Lemo (2-pin) or 2.1mm DC. The plug-in output units allow you to customise the PowerHub to your individual requirement. The USB output allows you to power 5V camera accessories that draw up to 2A continuously, 3A peak, or charge your phone.

POWERHUB CAN ONLY BE USED WITH PAGLINK BATTERIES & CANNOT BE CONNECTED DIRECTLY TO THE CAMERA OR USED WITH NON-PAGLINK BATTERIES